Setting Flowcontrol mode in UT-4 interface

Solution:

Please follow steps below:

1. Run Windows console: Start > Run > and type „cmd” and click OK,
2. Run Telnet software to log in UT-4 device by typing: „telnet”, for example „telnet 192.168.0.70”,
3. Login window appears, user is „root”, password is „dbps”,
4. After log in put command: „set serial flowcontrol=none”,
5. To verify if settings are saved correctly put command „show serial” - value in Flowcontrol columns should be set to none,
6. To close Telnet software type „quit” and then „exit”.